Raising And Lowering The Lcd Brightness; Raising And Lowering The Charge Led Brightness; Setting The Home Hold Time; Changing The Remote Inactivity Page Flip - AMX MIO-R4 Instruction Manual

NOTE: Make sure to adjust the Sleep Timeout period after disengaging the Sleep on Display Timeout function. From the factory,
the default sleep timeout will be set for 15 minutes, but engaging and then disengaging the Sleep on Display Timeout function
will reset the period for 0 minutes (will not sleep until the battery charge runs low) because the previous setting will already have
0 for that setting, even though it was not actually used.
5. Select the Back button until you are out of the Setup Menu.
NOTE: While deactivating the Sleep on Display Timeout function will prevent the Mio R-4 from going offline when the selected
Display Timeout time is reached, doing so will decrease the effective battery life. Setting the Sleep Timeout period to 0 will keep
the device from disconnecting from the network, but even a fully charged battery will reach a very low point within 10 to 14
hours. If the device's battery is too depleted, it may need to be returned to the charging cradle and recharged before it can be
used again.

Raising and Lowering the LCD Brightness

1. Select Remote & Display Settings from the Setup Page.
2. Under LCD, use the Up/Down arrows to adjust the LCD brightness in one-point increments, from a minimum of 0 to a
maximum of 100.
NOTE: Take care not to set the LCD brightness too low, as the screen may become too dark to read. If you accidentally set the
LCD brightness too low and the screen becomes too dark, touch the center right of the touchscreen until the screen brightens
again.
3. Select the Back button until you are out of the Setup Menu.

Raising and Lowering the Charge LED Brightness

1. Select Remote & Display Settings from the Setup Page.
2. Under Charge LED, use the Up/Down arrows to adjust the LED brightness in one-point increments, to a minimum of 0 and a
maximum of 100.
3. Select the Back button until you are out of the Setup Menu.

Setting the Home Hold Time

1. Select Remote & Display Settings from the Setup Page.
2. Under Home Hold Time, use the Up/Down arrows to adjust the home hold time in one-second increments, to a maximum of 6.
NOTE: A setting of 0 has special meaning: it disables the "home" function on button hold, allowing the back/home button to
operate like other external buttons.
3. Select the Back button until you are out of the Setup Menu.

Changing the Remote Inactivity Page Flip

1. Select Remote & Display Settings from the Setup Page.
2. Under Inactivity, use the Up/Down arrows to adjust the page flip time in increments, to a maximum of 240.
3. Select the Back button until you are out of the Setup Menu.

Checking Remote Display Settings

1. Select Remote & Display Settings from the Setup Page.
2. Use the device's arrow down to navigate to the fourth and fifth Display Settings pages.
3. Select the Back button until you are out of the Setup Menu.

Date/Time Settings

The date and time can be set on the device or you can use the NetLinx Master to establish the time and format used. Use the up and
down arrows to scroll from viewable page to page.
Date/Time Settings Pages
FIG. 8
Mio Modero R-4 Remote - Instruction Manual
Device Setup Pages
16