Installation Instruction; Installation - Ariston HW65/9H Instruction Manual

·Children should use this product for shower under the instruction of other adults.
·In order to avoid injury caused by hot water, it is suggested to release cold water first from water-
mixing valve and then add hot water to get the temperature suitable for use.
·There should be no flammable and explosive material around this product.
·Do not turn off the power when it is running in case ProTech titanium-plated ion bar goes wrong.

4. Installation Instruction

4.1 Installation

A. Requirements on Product's Installation Position and Load-bearing Wall
·It should be installed at the nearest place where there is outlet, drainage or floor drain for
condensate nearby. If the distance between this product and the installation place is more than 8
meters, then the pipelines should be treated heat preservation finish.
·It should not be installed at kitchen and alike places where there are too much smoke,
electromagnetic wave, unstable voltage and acid or alkaline vapor.
·Its air inlet should not be close to high-temperature heat source, such as bathroom-master, or get
in the way of air inlet.
·Make sure the load-bearing wall can support the weight 4 times of a completed filled water heater.
·Before determining where bolt hole should be and in order to reserve the space needed to open
side panel to perform maintenance operation, it is necessary to make sure that the distance of both
sides of the product from the load-bearing wall is no less than 350mm. This product is better not to
be installed at the ceiling or semi-suspended ceiling.
Note: It is strictly prohibited to vertically install this product.
If it is installed at bathroom or some other narrow space, there is a possibility that you will be
bothered by overflow, noise and decrease of indoor temperature. Please be well prepared for these
problems.