Operation Mode Option; How To Choose Intelligent Heating Pump And Fast Wash; How To Choose Operation Mode; Timing Mode - Ariston HW65/9H Instruction Manual

press power switch for the second time at this point, then the system will quit operation and change
to standby. The next time the system is initiated, repeat above steps.
Note: The default operation mode is standard mode.

8. Operation Mode Option

8.1 How to Choose Intelligent Heating Pump and Fast Wash

After being turned on and displayed as intelligent heating pump, the system would automatically
choose the best energy-saving way to heat the water. If you push "Fast Wash" button at the
operation interface then fast wash heating mode is activated. You can also terminate fast wash
function by pushing "Fast Wash" button after it is activated. When the water temperature reaches
setting degree then fast wash function, which heats the water in a way that takes minimum time,
will terminate automatically and switch back to intelligent heating pump.

8.2 How to Choose Operation Mode

Turn on the system and enter operation interface, then press "mode" button to enter operation
mode selection, there are three modes, "timing mode", "night mode" and "standard mode". If you
press switch button for a long time after the system is turned on, then "sleep mode" will be
activated.

8.3 Timing Mode

Activate "Timing Mode" under the instruction described in 8.2 and the system will automatically
choose the right operation mode according to assigned time because it is a preset mode which
allows the user to set mode time and temperature by pressing "Setting" button then the system will
heat the water in advance to the temperature set previously.
Note:
* The time window available to the user is half an hour
* The time set by the user is when he/she would use the water and there are two time points
available. The system will automatically calculate the real-time data and activate heating mode
according to the result. When timing 1 is in operation, it will flash and it's exactly the same with
timing 2.

8.4 Night Mode

Activate this mode under the instruction described in 8.2 and the system will automatically select
the suitable mode to heat the water from 23:00 pm to 6:00 am to the temperature set previously.