ATEN Master View CS-1004 User Manual page 23

w F6 Set:
When you press [F6] a submenu appears that allows you to configure the OSD
settings. To change a setting, use the Up and Down Arrow Keys or mouse to
move the highlight bar to it, then press [Enter] or Double Click the left mouse
button.
Selecting Port ID Display Duration, Port ID Display Position, Port ID Display
Mode, and Scan Duration brings up submenus of their own with choices for you
to select. Move the Highlight Bar to the choice you want, then press [Enter] or
Double Click the left mouse button. An icon appears before the choice to
indicate that it is the currently selected one.
The settings are explained in the table below:
Setting Function
Determines how long a Port ID is displayed for. There are
PORT DISPLAY two choices: 3 Seconds - which displays the Port ID for 3
DURATION seconds after a port change has taken place; and Always -
which displays the Port ID at all times.
Selects how the Port ID is displayed: the Port Number plus
PORT DISPLAY
the Name (PN + NAME); the Port Number alone (PN); or
MODE
the Name alone (NAME).
Allows you to position where the Port ID appears on the
screen. Use the Arrow Keys, Pg Up, Pg Dn, Home, End,
PORT DISPLAY
and 5 (on the numeric keypad with Num Lock off), to
POSITION
position the Port ID display, then press [Enter] to lock the
position and return to the Set submenu.
Determines how long the display dwells on each port as it
SCAN DURATION cycles through the selected ports in Quick View Scan Mode.
The options are: 3, 5, 10, 15, 20, 30, 40, and 60 seconds.
Clears all Port Names from the Name List. You are asked to
confirm before the procedure goes on. While the names are
CLEAR NAME LIST being cleared, a message appears on the display to indicate
so. After the names have been cleared, another message
appears to indicate that the procedure completed successfully
Clears all settings from memory, and returns the unit to the
factory defaults. You are asked to confirm before the
RESTORE DEFAULT procedure goes on. While the settings are being cleared, a
VALUES message appears on the display to indicate so. After the
settings have been cleared, another message appears to
indicate that the procedure completed successfully.
CS-1004 / CS-1008 / CS-1016 User Manual 19
2001-01-13