Saeco Xsmall Plus Service Manual page 14

03 BRIEF INSTRUCTIONS
Indications
Coffee bean container empty
Dreg drawer full
Fixed
Water circuit drain
Blinks quickly
Brewing unit not present
Dreg drawer not present
Blinks slowly
Service hatch open
Valve position NOT suitable for machine
operation
The machine is performing its rinse /
Blinking in an anti- automatic cleaning cycle
clockwise sequence
- When the machine is switched on (the
(cyclically)
boiler is cold)
- After fi lling the circuit (the boiler is
+
cold)
- Before the machine enters Standby
mode (if it has dispensed a coffee)
- During the shutdown phase, after the
ON/OFF key has been pressed (if the
machine has dispensed a coffee)
The machine is experiencing a fault and
Blinking simultaneously
will not dispense coffee, water or steam
+
The brewing unit has experienced a fault
Blinking in
alternating
fashion
Page 2 / 3
Causes
Fill the coffee bean tank.
Empty the dreg drawer while the
machine is switched on.
If the drawer is emptied before the
indication appears and the drawer
remains out of position for at least
5 seconds, the dregs counter will
still be reset.
Fill the tank with fresh drinking wa-
ter and fi ll the water circuit of the
machine by turning the selector to
the "
ous jet of water to come out of the
steam hose.
To stop the red blinking light, make
sure that all components are insert-
ed or closed correctly.
The machine ends the cycle auto-
matically.
The cycle may be stopped by press-
ing one of the two coffee keys.
Switch the machine off, wait for
30 seconds and switch it back on
again.
Repeat 2 or 3 times.
If the machine does not start, enter
test mode.
Try to carry out a coffee dispensing
cycle again.
Rev. 00 / Jul. 2008
XSMALL
Solutions
" point; wait for a continu-
Saeco Int.