Quick Compare - Addonics Technologies CFASTD5 User Manual

Press ENT to enter the following figure. The default is 0. Use the Up and Down arrow keys to
choose 5 Sec-50 Sec.
Tolerance Size
This option is used to set the tolerance in terms of percentage difference between
the source and target capacity. This is to ensure that when the target drive is
smaller than the source drive, the duplication process will not start.
Press ENT to enter the following figure. The default is 0. Use the Up and Down arrow keys to
choose 1MB~100MB of source.
BootTime Delay
This opti o n is used to to set boot delay time.
Press ENT to enter the following figure. The default is 5 sec. Use the Up and Down arrow keys to
choose 0~99 sec.

Quick Compare

This opti o n is used to set t h e size of each comparison unit.
Press ENT to enter the following figure. The default is 0. Use the Up and Down arrow keys to
choose 1 Byte/1K/10K/100K/1MB/10MB/100 Mbytes. (In order to improve the accuracy of pure
data can maintain the default settings.)
www.addonics.com
Auto Start Timer
10-11. Setup
Tolerance Size
Tolerance Size
1MB
10-12. Setup
BootTime Delay
BootTime Delay
5 sec
10-13. Setup
Quick Compare
Quick Compare
Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/