Data Video SE-700 Instruction Manual page 51

Q: Is CUT transition available for DSK function?
DSK function supports CUT transition from firmware version V 1.1.0.5 onwards.
Q: What are the expected behaviors of PIP/LUMA/DSK buttons?
PIP PVW/Keyer PVW/DSK PVW Button ON: Effect displayed on PVW Screen; after configuring parameters
of PIP/Keyer/DSK, enable PIP PGM/Keyer PGM/DSK PGM to switch PIP/Keyer/DSK to PGM Screen (or the
user can use CUT or T-Bar to perform transition; CUT is not available for DSK though). If only PIP
PGM/Keyer PGM/DSK PGM are enabled, then the effect is displayed on both PVW and PGM screens.
Q: Why can't image captured using the Freeze function be found after the SE-700 is restarted?
Image captured using the Freeze function will be lost after power is switched off. However, you can save
it as a still image if you want to keep it.
Q: Can PIP/KEYER/DSK be enabled at the same time?
Yes, PIP/KEYER/DSK can be enabled at the same time with PIP at the bottom most layer, Keyer in the
middle and DSK on the topmost layer.
Q: 720p Video output on HDMI-1 cannot be displayed on TLM-700HD.
Please use TLM-170H/170P/434H for such application.
Q: Parameter scroll is only one-direction, i.e. once the end of the list is reached, the user should
reverse the direction of the scroll to go back to another end of the list.
Some of the parameters allow the user to cycle through the available values, whereas other parameters
allow only one direction scroll.
Q: Is there any indication of PIP/Keyer/DSK enable?
There are two indications of PIP/Keyer/DSK enable:
1. There are tally indications for channels set to key and fill sources of PIP/Keyer/DSK.
2. Borders of screens of the multiscreen assigned to PIP/Keyer/DSK will be lit with a color. Also, the
PIP/Keyer/DSK button will be lit.
Q: The user is prompted of the warning of insufficient volume capacity while updating firmware on
WIN8 Operating System.
In the case of upgrading the keyboard firmware, the user should delete the original firmware file first
before copying the new firmware file to the device.
Q: MENU Setup options are not included in the Last Memory.
To remember the new MENU Setup settings, the user must execute SAVE function.
Q: When will "Auto Save function" be triggered?
Auto Save occurs when a new Menu Group is selected, also when the PC Controller App is exited.
Q: What are the 3 mini-pics below the Load Stills menu buttons?
The OSD Stills Menu now shows 3 mini-pics below the Load Stills menu buttons, and these are shown as
8-level black & white images. The Stills/ Still Num & Load buttons are also swapped.
51