Data Video SE-700 Instruction Manual page 11

Function Keys F1-
F3
User Memory 1-6
Menu Control
Wipe Transition
Selection
11
F1: Switch USER 1-6 buttons to act as USER 7-12
buttons
F2: User Mem Save
Press and hold for 2 seconds
All user buttons will flash (Blue LED)
Press a user button to save the current setting
(To turn off flashing LED without saving, press F2
again)
F3: Reset Button
Mode 1 - When in Menu Select mode (left hand
column of the OSD menu), pressing the 'Reset'
button will reset all current menu items to their
factory defaults.
Mode 2 - When in a Sub-Menu, pressing the 'Reset'
button will reset the current menu line only.
User Memory buttons 1-6 allow the user to
quickly recall and load previously saved switcher
settings with a single button press. This includes
PIP, Keyer and DSK settings. F1 button changes
these keys to User memories 7 to 12. The
switcher loads settings saved to User Memory 0
as default settings used at boot up. See the User
Memory section for more information.
Menu Operation
Press the MENU button to gain access to the
menu; use the up/down/left/right arrow buttons
to browse through the menu and press ENTER
button to select an option or MENU button to
exit.
WIPE Transition Selection
Each Wipe button consists of black and white
colors. The white represents the current Program
image and the black represents the WIPE-IN
image. There are a total of 32 WIPE presets
offered on the SE-700; the WIPE buttons allow
the user to make a selection directly from the
control panel for the first 12 and remaining 20
WIPE effects are selectable from the menu.