Accessory Lighting - Amana SS 5 Use And Care Manual

Burner grill w/ rear burner

Hide thumbs Also See for SS 5:

Use and care manual (32 pages)

Table Of Contents

Table of Contents

ROTISSERIE LIGHTING

Open the lid. Push and turn the control knob for the

rotisserie counter clockwise to the " HIGH" position.

Wait 5 seconds. Then press and hold the electronic

igniter button. You' ll hear a snapping sound. If the

burner does not light in 4 seconds, turn the control

knob to OFF and wait 5 minutes before trying again.

Once lit, turn the control knob to the desired setting.

(See Fig. 55)

If the igniter does not function, the burner can be lit by

holding a lit match to the burner while the control knob

is turned counter clockwise to " HIGH" . (See Fig. 56)

NOTE: After the first use the stainless steel around

the burner will darken. This is a normal reaction of

premium stainless steel to heat and is not a defect.

The infrared panel will also darken after initial use.

This is also a normal occurrence.

NOTE: Do Not operate the main

burners and infrared back burner at

the same time. This can cause

warping of the roll top grill hood.

SIDE BURNER LIGHTING

Push and turn the side burner control knob to the

" HIGH" position and immediately press and hold

the electronic igniter button. You' ll hear a

snapping sound. It may be necessary to hold the

electronic starter button for about 4 seconds. If

the burner does not light in 4 seconds, turn the

knob to the " OFF" position and wait 5 minutes

before trying again. Repeat above steps to light

remaining burners. (See Fig. 57)

MATCH LIGHTING OF THE BURNER

If by chance the electronic igniter does not light the

burner, the burner may be lit with a match. Keep

your face as far away from the burner as possible

and place a lit, long stem match through the

spaces in the grate to the ports of the burner.

Position the match near the burner ports and

push and turn the control knob to the " HIGH"

position. (See Fig. 58)