WinSystems PPM-C407 Product Manual page 68

Progress and Error Codes
Table C–3: Progress and Error Codes
Code
01 COMP_PEI_BEGIN
02 COMP_PEI_END
03 COMP_DXE_BEGIN
04 COMP_DXE_END
05 COMP_SUPPORTED
06 COMP_START
07 COMP_STOP
08 COMP_SMM_INIT
09 DEVICE_ERROR
0A RESOURCE_ERROR
0B DATA_CORRUPT
0C COMP_PEI_CALLBACK
0D COMP_DXE_CALLBACK
v1.0
Progress and error codes are only displayed on POST diagnostic displays that show
four digits. On these displays, the most significant two digits show the progress or error
code from the table in this section (Progress and Error Codes), while the least
significant two digits show the diagnostic code (see tables above). For example: 0345
indicates the component was loaded, the DXE/UEFI entry point called, and DXE driver
initialization of the HDD password feature.
Symbol
The component was loaded and the PEI entry point called
The component returned from the entry point
The component was loaded and the DXE/UEFI entry point called
The component returned from the entry point
The Supported() member function of the component's instance of the
Driver Binding protocol was called
The Start() member function of the component's instance of the Driver
Binding protocol was called
The Stop() member function of the component's instance of the Driver
Binding protocol was called
The component was loaded and the entry point called inside of SMM
The driver encountered a condition where it cannot proceed due to a
hardware failure
The driver encountered a condition where it cannot proceed due to
being unable to acquire resources
The driver encountered a condition where it found invalid data and
could not continue
The component received a callback in PEI phase
The component received a callback in DXE phase
www.winsystems.com
PPM-C407/Power-on Self-Test (POST) Codes
Description
Page 64