Table of Contents
Advertisement
Then choose your preferred setting among External Alarm (when activated, this pin goes to
GND level. It is used to command an external buzzer), External Power (it is command switch for
the Radar. It must be used in conjunction with the Radar Junction box device) and Off.
Cable Wiring pages
This menu allows you select the Cable Wiring page:
[MENU] + "Advanced Options" + [ENTER] + "Input/Output"+ [ENTER] + "Cable Wiring" +
[ENTER]
Power I/O Cable Wiring 1
Quick Disconnect Cable Wiring 2
GPS Cable Wiring 3
AUX In I/O Cable Wiring 4
NOTE 1
Available For SNS 1100
NOTE 2
Available For SNS 700e/SNS 700i/SNS 700fe/SNS 700fi.
NOTE 3
Available For SNS 700e/SNS 700fe/SNS 1100
NOTE 4
Available For SNS 700e/SNS 700i/SNS 700fe/SNS 700fi/SNS 1100
Send/Receive Routes & Marks
Sets the desired port used for transferring User Points and Routes functions:
[MENU] + "Advanced Options" + [ENTER] + "Input/Output" + [ENTER] + "Send/Rec Rts & Mrks"
+ [ENTER] + "Port n" + [ENTER]
Where:
n =
1/2/3/4/5 for SNS 700e/SNS 700i/SNS 1100
n =
1/3/4/5 for SNS 700fe/SNS 700fi
3.6.2
C-Link menu
Select the Primary or Secondary Station (see the dedicated Chapter):
MENU] + "Advanced Options" + [ENTER] + "C-Link" + [ENTER] + "Secondary Station/Primary
Station" + [ENTER]
3.6.3
Fix & Compass menu
To handle the functions related to navigation and to set the reference heading information such
as bearing angles (True or Magnetic), the Magnetic Variation source and to enter Compass
Calibration values.
[MENU] + "Advanced Options" + [ENTER] + "Fix & Compass" + [ENTER]
Fix Correction
52
- User Manual
Shows a window containing the Power I/O cable
wiring.
Shows a window containing the quick disconnect
bracket cable wiring.
Shows a window containing the GPS cable wiring.
Shows a window containing the AUX IN I/O cable
wiring.
Turns On/Off the Correction from the positioning
system. If the new Correction is calculated, but the
Correction is not enabled, the ship's position is not
changed.
Advertisement
Table of Contents
