Restoring Defaults - Gira G1 Installation And Operating Instructions For The Installer

Settings
3 Place your finger on the movement point of the required entry and move the
functions to a sequence that suits you.
4 Move additional entries using the same method.
5 Touch [OK] when you have finished.
? The [View configuration] page is opened.
6 Finish and save your settings: Touch [OK] to do this.
A message appears telling you that changes are being saved and the Gira G1
?
is restarting.
7 Confirm this information with [OK].
The Gira G1 is restarted. Then, the favorites appear in the action area in the
?
sequence you have defined.
4.1.3.4

Restoring defaults

Here, you can restore the view of the action area to the original status defined
in the ETS project planning.
1 Open the [View configuration] page.
2 Touch the [Restore defaults] button.
? A message is displayed asking you whether you want to reset all settings to
the original status after start-up.
Confirm this information with [OK].
The Gira G1 is restarted. The favorites appear in the action area in the original
?
status after start-up.
Gira G1 installation and operating instructions
0.258 21/2015
21