Cadillac Escalade EXT Owner's Manual page 395

$10araEscaladeEXT Page 395 Wednesday, October 14, 2009 9:54 AM
1. Check under the vehicle to see
if the cable is visible.
2. If the cable is not visible,
proceed to step 4.
If the cable is visible, tighten
the cable by turning the wheel
wrench clockwise until it clicks
or skips twice.
The cable cannot be overtight-
ened.
Loosen the cable by turning
the wheel wrench counter-
clockwise three or four turns.
Tighten and loosen the cable
at least two times.
If the tire lowers to the ground,
continue with Step 10 of this
procedure.
If the tire does not lower to the
ground, continue with this
procedure.
3. Turn the wrench counterclock-
wise until approximately
15 cm of cable is exposed.
Section 5
4. Stand the wheel blocks on
their shortest end, with the
backs facing each other.
5. Place the bottom edge of
the jack on the wheel blocks,
separating them so that the
jack is balanced securely.
395 . . .
–
–
–
–
–