$10araEscaladeEXT Page 165 Wednesday, October 14, 2009 9:54 AM
If no switches are present, the
device operates with a rolling
code.
A different signal is sent each time
the button is pressed.
See the following, later in this
section, for information:
• Rolling Code Transmitters
FIXED CODE TRANSMITTERS
Read through all of the following
programming procedure before
you begin customizing this
feature.
1. Examine the hand-held
transmitter to verify that the
device operates with a fixed
code. See "Determining the
Code Type" earlier in this
section.
- Note
If the hand-held transmitter
is lost, proceed with the next
step.
2. Check the motor head unit for
the device to verify if switches
exist on the unit.
Section 1
3. Compare any existing
switches on the motor head
unit to those of the hand-held
transmitter.
If the total number of switches
or the switch settings on the
motor head unit are different
than those of the hand-held
transmitter, or if the original
transmitter is lost, use the
switches on the motor head
unit to program the device.
165 . . .
–