Care And Maintenance; Fault Instructions; Switch Power Filter Clean Off; Clean Electrodes - Kärcher NT 361 ECO Manual

English

Switch Power Filter Clean off

Setting of the slide (1) - upwards
Note:
♦ When vacuuming wet dirt with the
upholstery or the crevice nozzle or if
predominantly water is to be
vacuumed out of a container it is
adviseable to turn the - Power Filter
Clean – operation off. .
♦ The appliance turns itself
automatically off when the max.
liquid level has been reached.
♦ Switch the appliance off and empty
the container.
♦ Clean and dry the flat pleat filter and
the electrodes as well as the
container after finishing wet
vacuuming jobs.
NT 361 Eco / NT 361 Eco TE

CARE AND MAINTENANCE

♦ Always pull out the mains plug when
working on the suction machine.
Replace the flat pleat filter or the
exhaust air filter
Open the filter cover (1)
Replace the flat pleat filter (2) or
the exhaust air filter (3)
Close the filter cover, it must engage
audibly

Clean electrodes

Unlock and remove the suction head
Clean electrodes
Replace the suction head and lock it
in place

FAULT INSTRUCTIONS

The suction turbine does not run
• Check the cable, plug, fuse and
socket.
• Switch on the machine.
The suction turbine switches off
• Empty the container.
The suction turbine does not restart
following emptying of the container
• Switch the appliance off and wait
for 5 s, switch it on again after 5 s.
• Clean the electrodes as well as the
space between them.
The suction power decreases
• Remove the parts clogging up the
suction nozzle, the suction tube, the
Power Filter Clean handle, the
suction hose or the flat pleat filter.
• Change the paper filter bag.
• Actuate the filter cleaner: Power
Filter Clean several times at the
handle.
• Engage the filter cover properly.
• Replace the flat pleat filter.
Dust ejects when sucking
• Check the proper mounting position
of the flat pleat filter.
• Replace the flat pleat filter.
The (wet-vacuuming) automatic
switch-off does not respond
• Clean the electrodes as well as the
space between them.
• Constantly check the filling level for
an electrical non-conductive liquid.
Power Filter Clean switches
regularly
• Loosen suction nozzle or end of
hose when caught on vacuumed
object.
• Stop continuous vacuuming from the
liquid container and turn
the operation - Power Filter Clean –
off (see section Wet-Vacuuming).
• Remove the parts clogging up the
suction nozzle, the suction tube, the
Power Filter Clean handle, the
suction hose or the flat pleat filter.
• Replace the flat pleat filter.
11