Mighty Mule FM402 Installation Manual page 33

Accessory Inputs
SAFETY: Typically for use with photo beam device, loop
1
detector or other non-contact sensors
• Activation of this input while the gate is closing will cause the
gate to stop and return to the opened position.
• Activation of this input while the gate is opening has no effect.
(gate will continue to open)
• Activation of this input while gate is idle will prevent gate from
closing.
• Activation of this input while at open limit will restart the auto
close time (if enabled).
EXIT: Typically for use with exit loop or wand
2
• Activation of this input will open the gate if it's not already at the
open position.
• Activation of this input while at open limit will restart the auto
close time (if enabled).
• Activation of this input while gate is idle will prevent gate from
closing.
CYCLE: Typically for use with doorbell button or hardwired
3
keypad
• Each activation at this input will cycle the operation as follows:
...→ OPEN → STOP → CLOSE → STOP → OPEN → ...
EDGE SENSOR: Typically for use with contact edge sensor
4
• Activation of this input while gate is moving will cause it to
reverse direction for 2 seconds.
• Activation of this input while idle will prevent gate from running.
COMMMON: Common/Negative terminal for accessory
5
devices.
12 Volt Power (Maximum Current: 100 mA)
COM: Common/Negative terminal for accessory power source.
5
LOCK +: Power source for GTO/Mighty Mule accessories, i.e. Gate Opening Sensor [FM138].
6
Lock Outputs
LOCK +: Positive terminal to connect Automatic Gate Lock [FM143].
6
LOCK – : Negative terminal to connect Automatic Gate Lock.
7
Charge Power Inputs
14VAC or SOLAR: Power Input Terminals:
8
• Input terminals for transformer or solar panel.
• Non-polarity sensitive.
rev 12-14-15
1st OPR.
OPEN < JOG > CLOSE
2nd OPR.
SET
PWR.
LIMIT
1
SFTY.
2
EXIT
3
CYCLE
EDGE
4
SENSOR
5 COMMON
6
LOCK+
7
LOCK–
WHT
GRN
RED
BLK
WHT
GRN
RED
BLK
14 VAC
OR
8
SOLAR
Mighty Mule FM402 Installation Instructions
STATUS
120
MIN
MAX OFF
SEC.
STALL FORCE AUTO CLOSE
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
VAR1
VAR2
VAR3
VAR4
VAR5
PF1
K1
K2
BATT +
BATT –
K3
K4
VAR6
ON OFF
JP1
23