Canon Elura 90 Instruction Manual page 100

100
Recording Motion JPEG Movies
on a
Memory Card
You can record Motion JPEG movies with the camc0rder, from a tape in the camcorder or
from devices connected via the DV terminal or the AV terminal. The sound of a movie
recorded on a memory card will be monaural.
I
1. Press the start/stop button to begin recording.
With SO Memory Cards up to 512 MB, you can record until
"CARD FULL" appears (approx. 33 minutes in 320 x 240 with a
512 MB SO Memory Card). With MultiMediaCards, the recording
time is limited to 10 sec. in 320 x 240 pixels and 30 sec. in 160 x
120 pixels.
2. Press the start/stop button to stop recording.
a
Do not turn off the camcorder, change the position of the TAPE/CARD switch,
disconnect the power source, open the memory card cover or remove the
memory card while the card access indicator is flashing. Doing so could result
in data damage.
a
When you are using a SO Memory Card, make sure that the protect switch is
set to allow recording.
a
Do not load/unload a cassette during recording.
a
We recommend using a Canon SO Memory Card, or a SO Memory Card with a
transfer rate of more than 2 MB/sec., right after you have formatted it with this
camcorder. With memory cards not formatted with this camcorder, or when
recording/erasing has been repeatedly performed, the writing speed may be
lower and recording may stop.
a
You can select the focusing point when recording a movie on the memory card.
a
Users of Windows XP: When you plan to connect the camcorder to a computer
using a USB cable, keep the length of one movie shorter than approx. 12 min.
in 320 x 240 and 35 min. in 160 x 120.
a
The recording time varies according to the movie size, the recoding condition
and the subjects.