Audio Recording - Canon Elura 90 Instruction Manual

Audio Recording
You can record sound in two audio modes-16-bit and 12-bit. The 12-bit mode records
sound on two channels (stereo 1), leaving 2 channels free (stereo 2) for adding new
sound later. Select the 16-bit mode for higher sound quality.
I
~~~)
[AUDIO SETUP
I~I
AUDIO MODE· .. 12bit
Open the menu and select [AUDIO SETUP]. Select [AUDIO MODE], set it
to [16bit] and close the menu.
"16bit" appears for approximately 4 seconds.
U~i.cgl:l.~aggbgc~~gu[iiCg
. . .
B.g~.Q.[gicg
The headphones terminal also serves as AV terminal. Headphones can only be used
when"
0"
is displayed on the screen. If not, change the setting following the procedure
below.
I
~~~)
I
VCR SETUP
I~I
AV!PHONES(/· 'AV
Open the menu and select [VCR SETUP]. Select [AV/PHONES 0], set it to
[PHONES 0] and close the menu.
Adjusting the Headphone Volume
I
~~~)
I
AUDIO SETUP
I~I
(/
VOLUME .... •
.-anO!llIJ
Open the menu and select [AUDIO SETUP]. Select [0 VOLUME], adjust
the volume with the SET dial and close the menu.
You can turn off the volume completely by turning the SET dial down until [OFF] appears.
Turn the SET dial up to increase the volume again.
61