Idle Periods; Internal Parts; Maintenance - Electrolux ARG24FLCE Manual

Attention: Do not use the edge scraper (see figure) as it
will scratch the plate, permanently compromising its
functionality and cleanability. Replace the blade whenever it
is not perfectly sharp.
COLLECTION TRAYS AND TANKS (even several times a day)
Remove any grease, oil, food residuals, etc., from tanks, trays
and containers in general used for collection. Always clean
the containers at the end of the day. While using the appliance,
empty them when they are nearly full.

3. IDLE PERIODS

If the appliance is not going to be used for some time, take
the following precautions:
• Close cocks or main switches ahead of the appliance.
• Go over all stainless steel surfaces vigorously with a cloth
moistened with paraffin oil in order to create a protective
film.
• Air the premises periodically.
• Have the appliance checked before using it again.
• To prevent too rapid evaporation of accumulated moisture
with consequent breakage of elements, switch electric
appliances on at minimum heat for at least 45 minutes
before reuse.

4. INTERNAL PARTS

IMPORTANT! Operations to be carried out only by
specialised technicians.
• Check the condition of internal parts.
• Remove any deposits of dirt inside the appliance.
• Check and clean the discharge system.
• Remove the 4 screws "V" and back "S" to access the
inner rear part of the appliance.
V
NOTE: In particular conditions (e.g. intensive appliance use,
salty environment, etc.) the above cleaning should be more
frequent.
28
(every 6 months)
S
VIII MAINTENANCE

1. MAINTENANCE

All the components requiring maintenance are accessible
from the front of the appliance, after removing the control
panel.
1.1 BRIEF TROUBLESHOOTING GUIDE
Even with normal use, malfunctions can occur.
The pilot burner does not light
Possible causes:
• Insufficient pressure in gas pipes.
• Blocked nozzle.
• Faulty gas valve.
The pilot burner goes out when the igniter knob is released
Possible causes:
• The pilot burner is not heating the thermocouple
sufficiently.
• Faulty thermocouple.
• The gas valve knob is not being pressed enough.
• Lack of gas pressure at the valve.
• Faulty gas valve.
The pilot burner is still lit but the main burner does not light
Possible causes:
• Loss of pressure in gas pipe.
• Blocked nozzle or faulty gas valve.
• Burner with gas outlet holes clogged.
The fry-top temperature cannot be adjusted.
Possible causes:
• Thermostat bulb faulty or not properly fitted.
• Faulty gas valve.