Download Table of Contents Print this page

The Environment; Packing; Use; Cleaning - Electrolux ARG24FLCE Manual

Advertisement

Table of Contents
IV. THE ENVIRONMENT

1. PACKING

The packing materials are environmentally friendly
and can be stored without risk or burned in an
appropriate waste incineration plant.
Recyclable plastic components are marked with:
Polyethylene: outer wrapping, instruction booklet
bag, gas nozzle bag.
PE
Polypropylene: roof packing panels, straps.
PP
Polystyrene foam: corner protectors.
PS

2. USE

Our appliances offer high performance and efficiency. To re-
duce electricity, water or gas consumption, do not use the
appliance empty or in conditions that compromise optimum
efficiency (e.g. with doors or lids open, etc.); the appliance
must be used in a well-ventilated place, to avoid the creation
of dangerous mixtures of unburnt gases in the room. When
possible, preheat only before use.

3. CLEANING

In order to reduce the emission of pollutants into the
environment, clean the appliance (externally and when
necessary internally) with products that are more than 90%
biodegradable (for further information refer to section VII
"CLEANING").

4. DISPOSAL

Do not disperse in the environment. Our
appliances are manufactured using more
than 90% (in weight) recyclable metals
(stainless steel, iron, aluminium, galvanised
sheet, copper, etc.).
Make the appliance unusable by removing
the power cable and any compartment or cavity closing
devices (when present) in order to avoid the risk of someone
becoming trapped inside.
V. INSTALLATION
Carefully read the installation and maintenance
procedures given in this instruction manual before
installing the appliance.
Installation, maintenance and conversion to
another type of gas must only be carried out by
qualified
personnel
manufacturer.
Failure to observe the correct installation, conversion and
modification procedures can result in damage to the
appliance, danger for people, and invalidates the
Manufacturer's warranty.

1. REFERENCE STANDARDS

This appliance must comply with the applicable federal,
state or local regulations.
These installation procedures must be carried out by
qualified personnel, otherwise the warranty will be
invalidated.
• AUSTRALIA: this appliance shall be installed only by
authorised persons and in accordance with the
manufacturer's installation instructions, local gas fitting
regulations,municipal building codes, electrical wiring
regulations, local water supply regulations, AS5601-gas
installation, health authorites and any other statutory
regulations.

2. UNPACKING

ATTENTION!
Immediately check for any damage caused during
transport.
The forwarder is responsible for the safety of the goods
during transport and delivery.
Inspect the packing before and after unloading.
Make a complaint to the forwarder in case of visible or
hidden damage, reporting any damage or shortages on
the dispatch note upon delivery.
The driver must sign the dispatch note: The forwarder can
reject the claim if the dispatch note is not signed (the forwarder
can provide the necessary form).
Unpack, taking care not to damage the
appliance. Wear protective gloves.
Carefully remove the protective film from metal surfaces
and clean any traces of glue with a suitable solvent.
For hidden damage or shortages becoming apparent only
after unpacking, request the forwarder for inspection of
the goods within and not later than 15 days of delivery.
Keep all the documentation contained in the packing.
authorised
by
the
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents