Exterior Shower - Fleetwood 1998 American Tradition Owner's Manual

12. When the tank is full, turn OFF the water supply valve.
13. Turn the TANK BYPASS valve to the right (clockwise) to close it.
14. On all models, turn VALVE 2 to horizontal.
15. Turn the water pump ON.
16. Open all faucets individually until water flows steadily, then
turn OFF. This will purge air from the lines.
17. Open the TANK BYPASS valve.
18.
Turn the water supply ON and top up the water tank.
19.
Let the solution set for three hours (sanitize only). If winter-
izing, the solution will remain in the system during freezing
temperatures.
20.
Drain the entire system by opening all drain valves, faucets,
and tank drain valves.
21. When the system is completely drained, repeat steps 9
through 16 to flush the system with fresh water. Be sure to
run water through each faucet for several minutes to thor-
oughly flush out the solution.
22. Fill the water tank, if desired. The system is now ready to
use.
A shower fixture is mounted in the basement utility compart-
ment, located on the left rear of the motor home. The water
pump must be ON or city water pressure must be available for
the shower to operate.
PLUMbiNCj SYSTEMS
EXTERioR ShOWER
.II
NOTE
The Hot and Cold knobs
on the exterior shower
fixture must be turned
OFF when not is use to
prevent uneven water
temperatures at galley,
lavy and shower fixtures.
- - - - - - - - - - - - - - - - - - -
AMERiCAN TRAdiTioN - CopyniqHT 1997, FlEETWood ENTEnpnisES, INC. All niqHTs nESERVEd.