Tunturi Platinum User Manual page 5

Step 3: Console and Small Covers
1. Plug the computer cable (31) and hand pulse cables
(38 x 2) into the corresponding connectors on the
back of the console (30). Mount the console on the
upright tube with four M5 x 12mm screws (119).
2. Install the four moving handlebar pivot covers (61, 62
left & 63, 64 right) with six 3.5mm x 12mm screws
(108).
3. Install the four covers (57x2 & 58x2) to the ends of
the pedal tubes with four M5 x 12mm screws (77)
and four 3.5mm x 12mm screws (108) .
3.
4. NOTE! These covers can be installed upside
down!! There is an arrow on the inside of each
cover to indicate correct installation direction.
5. Install the four covers (59 & 60, 2 pcs each) at
the connection point at the bottom of the moving
handlebars using four 3.5mm x 12mm screws
(108) and four M5 x 12mm screws (77). Install
the front support tube cover (51) with two M5 x
12mm screws (77).
Cross Trainer
5