Changing The Bulbs - Sachs Bikes 2006 X-Road 250 Owner's Manual

NOTES ON MAINTENANCE

Changing the bulbs

2
1
1
NOTE
Use only tested, incandescent bulbs with
the 'E' designation. Use of non-approved
bulbs will void the operating license. Do
not touch the bulbs with bare fingers. Hold
bulbs with a clean, dry cloth when installing
or removing them.
Headlight
low beam - high beam
HS1 12 V 35/35W E1
bulb
Position light
bulb 12V/5W
56
3
4
- Remove the screws (1) on both sides.
- Take off the front cover (2).
- Detach the plug (3) and the rubber cover
(4) from the headlamp.
- Disconnect the holder clamp (6) and pull
out the bulb (7).
6
7
5
- Pull the parking light bulb (5) with the bulb
holder out of the reflector.
Installation takes place in reverse order to
disassembly.