Indoor Unit - Panasonic CS-RE9SKUA Service Manual

12.2 Indoor Unit

12.2.1 How to Fix Installation Plate
The mounting wall shall be strong and solid enough to prevent it from the vibration.
Measuring
Tape
RE18SKUA, RE24SKUA
The center of installation plate should be at more than
The distance from installation plate edge to ceiling should more than
From installation plate left edge to unit's left side is
From installation plate right edge to unit's right is
○
B : For left side piping, piping connection for liquid should be about
: For left side piping, piping connection for gas should be about
1 Mount the installation plate on the wall with 5 screws or more (at least 5 screws).
(If mounting the unit on the concrete wall, consider using anchor bolts.)
Always mount the installation plate horizontally by aligning the marking-off line with the thread and using
o
a level gauge.
2 Drill the piping plate hole with ø2 3/4" (ø70 mm) hole-core drill.
Line according to the left and right side of the installation plate. The meeting point of the extended line is
o
the center of the hole. Another method is by putting measuring tape at position as shown in the diagram
above. The hole center is obtained by measuring the distance namely 5 1/16" (128 mm) for left and right
hole respectively.
Drill the piping hole at either the right or the left and the hole should be slightly slanting to the outdoor
o
side.
12.2.2 To Drill a Hole in the Wall and
Install a Sleeve of Piping
1 Insert the piping sleeve to the hole.
2 Fix the bushing to the sleeve.
3 Cut the sleeve until it extrudes about 19/32"
(15 mm) from the wall.
When the wall is hollow, please be sure to use the
sleeve for tube assembly to prevent dangers
caused by mice biting the connection cable.
4 Finish by sealing the sleeve with putty or
caulking compound at the final stage.
Wall
More than
Indoor unit
9 17 / "
32
(241.5 mm)
5 1/16"
(128 mm)
Model
CAUTION
Wall
1
More than
screw
2
2
3
5 1 / " (128 mm)
16
6
5
Installation plate
For best strength of
INDOOR unit installation,
it is highly recommended
to locate " " at 5 position
as shown.
○ ○
1 2
23 7/32" 3 7/32"
590 mm 82 mm
○
1 at right and left of the wall.
○
2 .
○
3 .
○
4 .
Indoor
Sleeve
for tube
assembly
ø2 3 /
4
through hole
41
More than 1
4
17
9 /
32
(241.5 mm)
1
5 1 / "
16
(128 mm)
Dimension
○ ○ ○
3 4 5
21 7/32" 20 15/16" 6 21/32"
539 mm 532 mm 169 mm
○
5 from this line.
○
6 from this line.
Wall
Outdoor
19
/
" (ø70 mm)
Putty or caulking compound
Wall
"
○
6
8 5/8"
219 mm
" (15 mm)
32
Approx. 7 /32" - 9 /32"
(5-7 mm)
Bushing for tube
assembly