Functional Overview - Stadler Form Viktor Operating Instructions Manual

• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• HPP-Filter: Failure to comply with the prescribed cleaning interval of 2
months results in a fire hazard!
• Prior to any maintenance work and after each use, switch off the appli-
ance and withdraw the adapter from the socket.

Functional overview

Preliminary filter The preliminary filter removes large dust particles and
pollutants from the air, thereby protecting the secondary filter from severe
soiling and optimising its functionality. The preliminary filter must be vacu-
um-cleaned regularly, 1–2 x per month depending on how dirty it is. Because
the filter material becomes worn out in the course of time, the preliminary
filter must be replaced after 6 months.
HPP™ Filter System The HPP™ filter is the heart of the air purifier. It
filters out viruses, bacteria, fine dust, pollen, dust mite excretions and mould
from the room air. Its high efficiency is ensured by the use of extremely
powerful magnetic fields. The HPP LED (8) shows the function status of the
HPP filter:
• LED is illuminated – HPP filter is installed and working faultlessly
• LED is not illuminated – HPP filter is not installed or does not work
• LED is diminished – HPP filter is dirty, clean according to the instructions.
The HPP filter must be cleaned every 2 months under cold running water
using detergent (see chapter "Cleaning").
Activated carbon filter The activated carbon filter is able to adsorb air-
borne gases (unpleasant odours or tobacco smoke) thereby filtering them
out of the air. Its capacity is finite, therefore the activated carbon filter must
be replaced every 6 months depending on the level of air contamination
caused by unpleasant odours and tabacco smoke. Should it become appar-
ent, even before the end of the 6 month period, that the unpleasant odours
are no longer being adequately eliminated, this is an indication that the filter
must be replaced.
Fragrance dispenser The fragrance dispenser fleece may be moistened
with a few drops of fragrance (max. 1–2 drops). Viktor will then give off
the fragrance into the room air, generating a comfortable ambiance. Please
note: if used in excess, fragrances may affect and damage the plastic mate-
rial. Therefore, please add no more than 1–2 drops to the fleece, and do not
add any more until the first fragrance is used up. If in doubt, please wash out
and dry the fragrance dispenser and fleece.