Sec 1: 8-22
NOTE: There are no other serviceable components on the Main Chassis Assembly (K).
8.8.2
Servicing Control Top Assembly (J)
8.8.2.1 Control Top Main Seal
1. Complete steps from
Disassembly" on page
2. Remove the Control Top Seal (10) with the Black Stick.
3. Replace the new seal into the groove provided in the Control Top Assembly's casting.
4. Ensure that seal is set properly and not stretched.
NOTE: There are no other serviceable components on the Control Top Assembly (J).
Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies
Chassis Ground Contact (6)
Figure 8-29. Remove Chassis Ground Contact
Figure 8-30. Control Top Assembly and Control Top Seal
Section 8.7.1.
1:8-12.
Control Top Assembly (9)
Control Top Seal (10)
through
Section 8.7.9.
of
Section "8.7 Radio