Sec 1: 8-16
8.7.5
Removal of the Back Chassis Assembly (E, M)
1. Dual Display version:
Gently separate the Back Chassis Assembly (E) from the Main Chassis Assembly (K) to
allow access to disconnect the flex connection between both chassis. This connector is
located near the top of the radio. Use the Black Stick to disconnect the connector as shown in
Figure 8-22.
Top Display version:
Back Chassis Assembly (M) has no connections and can be removed by just separating the
the two chassis apart.
Back Chassis Assembly (20)
Figure 8-22. Remove Back Chassis Assembly from Main Chassis Assembly
Pull the flex connector vertically upwards by using black stick
through the pull belt to avoid damaging it.
Disassembly/Reassembly Procedures: Radio Disassembly
Pull Belt
Black Stick
Connector