Disassembly/Reassembly Procedures: Radio Disassembly
Antenna Spanner Nut (19)
Antenna Washer (18)
iv. Gently lift the Control Top Bezel Assembly (11) and with the aid of the Black Stick, pop
8.7.9
Removal of the Control Top Assembly (J)
i. Use a Torx Plus IP8 bit to remove the two Control Top Screws (31). See
NOTE: Ensure the Control Top flex is disconnected from the VOCON Board (G, O) to
Control Top Screws (31)
Frequency Knob (13)
Figure 8-25. Remove Knobs and Fastener Hardware
the Secure Lever (14) off the Frequency shaft as shown in
Figure 8-26. Remove Control Top Bezel Assembly
prevent damage to the flex or connector.
Figure 8-27. Remove Control Top Assembly (9)
Volume Knob (12)
Torque Adder (15)
Volume Spanner Nut (17)
Volume Washer (16)
Figure 8-26.
Secure Lever (14)
Control Top Bezel Assembly (11)
Control Top Assembly (J)
Sec 1: 8-19
Figure 8-27.