Table of Contents
Advertisement
9 MANUAL LOOP (CUE LOOP) mode button
Press:
Sets the manual loop mode.
[SHIFT] + press:
Serato DJ
Sets the cue loop mode.
a SAMPLER (BANK) mode button
Press:
Sets the sampler mode.
[SHIFT] + press:
Serato DJ
Sets the bank mode.
b Pads
a
Pad 1
b
Pad 2
c
Pad 3
d
Pad 4
Various performances can be achieved using the pads.
= Using the pads (p. 15 )
= Using pad trans (p. 18 )
c f button
Press:
Use this to play/pause tracks.
d CUE ( ) button
Press:
This is used to set, play and call out temporary cue points.
! When the [CUE (
)] button is pressed while pausing, the tempo-
rary cue point is set.
! When the [CUE (
)] button is pressed during playback, the track
returns to the temporary cue point and pauses. (Back Cue)
! When the [CUE (
)] button is pressed and held after the track
returns to the temporary cue point, playback continues as long
as the button is pressed in. (Cue Sampler)
! When the [f] button is pressed during cue sampling, play-
back continues from that point.
[SHIFT] + press:
Loads the previous track in the library panel. (Previous Track)
! If the current playback position is not the beginning of a track,
the track returns to the beginning.
e SYNC (OFF) button
Press:
The tempo (pitch) of tracks on adjacent decks can be synchronized
automatically.
[SHIFT] + press:
Cancels the sync mode.
f SHIFT button
When another button is pressed while pressing the [SHIFT] button, a
different function is called out.
Mixer section
1
9
2
a
b
3
4
5
6
7
8
1 TRIM control
Adjusts the size of each channel's volume.
2 EQ (HI, MID, LOW) controls
Boosts or cuts frequencies for the different channels.
3 FILTER control
Applies the filter effect for the respective channel.
The original sound is output when the control is at the center
position.
Turn counterclockwise: Gradually decreases the low-pass filter's cut-
off frequency.
Turn clockwise: Gradually increases the high-pass filter's cutoff
frequency.
4 Headphones CUE button
Press:
The sound of channels for which the headphones [CUE] button is
pressed is output to the headphones.
! When the headphones [CUE] button is pressed again, monitoring
is canceled.
5 Channel level indicator
Displays the sound level of the respective channels before passing
through the channel faders.
6 Channel fader
Move:
Adjusts the level of audio signals output in each channel.
[SHIFT] + move:
Serato DJ
Use the channel fader start function.
7 FILTER FADE ON button
Turns the filter fade function on and off.
= Using the filter fade function (p. 17 )
8 Crossfader
Switches between the audio output of the left and right decks.
9 MASTER LEVEL control
Adjusts the master sound level output.
1
2
3
4
6
9
En
Hide quick links:
Advertisement
Table of Contents
