Registering A Unit - Panasonic KX-TG5511AL Operating Instructions Manual

Programming
This feature allows the unit to reject calls
from specified phone numbers that you
do not want to answer such as junk calls.
When a call is received, the unit does not
ring while the caller is being identified. If
the phone number matches an entry in
the call barred list, the unit sends out a
busy tone to the caller, and then
disconnects the call.
Important:
L When the unit receives a call from a
number that is stored in the call barred
list, the call is logged in the caller list
(page 27) with 7 after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in
the call barred list by using the caller list
or by entering the numbers directly.
Important:
L You must store the phone number
with an area code in the call barred
list.
■ From the caller list:
1
{<} (y)
2
{V}/{^}: Select the entry to be
barred. i I
3
{V}/{^}: "Caller Barred" i
M
4
{V}/{^}: "Yes" i M i
{ic}
■ By entering phone numbers:
1
8 i {#}{2}{1}{7} i m
2
Enter the phone number (24
digits max.). i M
L To erase a digit, press ^.
3
{ic}
Viewing/editing/erasing bar call
numbers
1
8 i {#}{2}{1}{7}
2
{V}/{^}: Select the desired entry.
24
L To exit, press {ic}.
3
To edit a number:
~ i Edit the phone number.
i M i {ic}
To erase a number:
W i {V}/{^}: "Yes" i M
i {ic}
Note:
L When editing, press the desired dial
key to add, ^ to erase.
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make
note of your new PIN. The unit will not
reveal the PIN to you. If you forget
your PIN, contact an authorised
service centre.
1
8 i {#}{1}{3}{2}
2
Enter the current 4-digit base unit
PIN (default: "0000").
3
Enter the new 4-digit base unit PIN.
i M i {ic}

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to
the base unit.
Important:
L The additional handset model
recommended for use with this unit is
noted on page 4. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.