Table of Contents
Advertisement
(PAGE 69)
G.
Clutch and Primary Drive
XS750-2D)
1 . Install clutch spacer, plate washer, and
clutch boss. Install the spring washer,
lock washer and locknut. Use the clutch
holding tool and special 32mm deep
socket
(special t o o l ) t o tighten the
clutch nut.
NOTE:
Bend over locking tab after locknut
tightened.
Clutch n u t torque:
,
2.
Install a clutch friction plate, then a
steel clutch plate. Install clutch friction
plates and steel plates alternately.
NOTE:
Each steel clutch plate has a tab. There
i s a d o t o n the clutch boss t o correspond
t o each tab. Install a clutch plate tab
next t o one dot. Position the next steel
plate next t o the next d o t o n the clutch
boss.
Follow this
around the clutch boss until
and steel clutch plates are installed.
I n this case, the friction plate w i t h cork
lining should be installed on the extreme
outside.
(XS750D,
(87
12.0
m-kg
f t - l b )
Main axle
Locknut
Lock wash
pattern clockwise
all friction
is
(PAGE 73)
N.
Piston and Cylinder
2D
1
)
4.
Position piston rings as shown.
NOTE:
1 ) Make sure ends of oil ring expan-
ders are n o t overlapped.
2)
Manufacturer's marks or numbers
stamped o n the rings are on the t o p
side o f the rings. Coat pistons and
rings well w i t h oil.
(UPPER R A I L )
5.
Install the cylinder. A ring compressor
is usually n o t necessary.
(PAGE 74)
P.
Camshaft installation
Delete the following sentences.
NOTE:
Manufacturer's
stamped o n the rings are o n the t o p side
of the rings. Coat pistons and rings well
oil.
w i t h
(XS750D. XS750-
( L O W E R
marks
or
numbers
Hide quick links:
Advertisement
Table of Contents
