VeriFone VX 520 Installation Manual page 24

T S
ERMINAL ETUP
Connecting Optional Devices
Connecting the
PIN Pad or Smart
Card Reader
to the
VX 520 Color D/E
CTLS
NOTE
24
VX 520 C D/E CTLS I
OLOR
Use the following procedures to connect a PIN pad or smart card reader.
When the VX 520 Color D/E CTLS terminal is powered via the corded power
supply, the terminal provides 8V DC, 2.25A or 9.3V DC, 4.0A. This power will
drive most VeriFone accessories. Contact your local VeriFone representative for
more information.
1
Remove the VX 520 Color D/E CTLS terminal rear cover.
2
Insert the USB or RJ-45-type connector of the PIN pad or smart card reader
into the port of the peripheral device.
To install a PINpad 101, PINpad 201, or PINpad 1000, position and insert the
grommet to secure the cable connection.
If a cable is not already connected to the smart card reader or PIN pad, insert
the small modular plug on one end of the interface cable into the optional
device's modular jack.
3
Insert the USB or the larger RJ-45-type connector on the other end of the PIN
pad cable into the PIN pad serial port on the terminal.
example of a smart card reader and PIN pad connection to the PIN pad serial
port.
Figure 12 VX 520 Color D/E CTLS Sample PIN Pad Connection
G
NSTALLATION UIDE
Figure 12 provides an