Stihl Cutquik TS 410-A Technical Information page 7

Technical Information 19.2010
5.4 Removing the Shroud
In addition to the previous description "Removing
the Shroud" in the Service Manual STIHL Cutquik
TS 410, 420, in machines with electronic water
control, the plug connection between the short
circuit wire and the control panel must be
disconnected.
1
. Loosen screw (1) – screw (1) remains in cap (2)
. Remove cap (2).
4
3
. Remove plug connector (3) from guide
. Unplug connector (3) between short circuit wire
and control panel
. Remove bolts (4)
5.5 Removing the Control Panel
Do not attempt to pry out the control panel with
shroud installed.
. Remove the shroud, see b 5.4
. Remove control panel from the snap mount
TI_19_2010_30_01_01.fm
5.6
In addition to the previous description "Removing
the Air Baffle" in the Service Manual
®
STIHL Cutquik
electronic water control, the plug connection
between the short circuit wire and the control panel
as well as the short circuit wire plug on the solenoid
valve must be disconnected.
2
.
.
4
.
.
.
.
.
Removing the Air Baffle
®
TS 410, 420, in machines with
2
Remove bolt (1)
Remove cover (2)
Disconnect the plug (3) of the short circuit wire
from the solenoid valve
Remove the shroud, see b 5.4
Remove the filter cover
Remove the support foot
Remove the air baffle with the short circuit wire
Page 7
1
3