Specifications - Stihl Cutquik TS 410-A Technical Information

Technical Information 19.2010
1.1.3 Using the Electronic Water Control
. Start the engine in accordance with the
Instruction Manual
. Blip the (+) button or (–) button with the thumb of
the right hand – the right hand always remains
on the rear handle during operation, the left
hand always remains on the handlebar – no
water is fed to the cutting wheel during idling
During use, the set amount of water is fed to the
cutting wheel.
. Adjust water flow if necessary – to do so, blip the
(+) button or (–) button with the thumb of the
right hand until the correct water quantity is
attained – the right hand always remains on the
rear handle during operation, the left hand
always remains on the handlebar
If the engine is idling, no water will be fed to the
cutting wheel – the electronic water control,
however, remains activated, so when work
continues, the last quantity of water set before the
idle phase will be fed to the cutting wheel again
automatically.
TI_19_2010_30_01_01.fm
1.1.4 Maintenance and Care
To protect the solenoid valve, a screen is installed in
the water connection.
If too little water or no water is fed to the cutting
wheel during use with the electronic water control
activated:
1
. Remove the coupling sleeve (1)
. Unscrew "water connection with screen" (2) and
rinse under running water – the screen remains
on the water connection
2.

Specifications

2.1 Weight
dry, without cutting wheel
without electronic water control
TS 410: 9.4 kg
TS 420: 9.6 kg
with electronic water control
TS 410-A: 9.9 kg
TS 420-A: 10.1 kg
Page 3
2