Technical Documentation - Stihl Cutquik TS 410-A Technical Information

Technical Information 19.2010
5.11 Repair times
The specified repair times apply for trained and
qualified personnel as well as for properly equipped
repair shops.
Code
2 Replace wheel guard
3 Replace wheel bearing bracket assembly.
4 Replace belt pulley on wheel arbor.
5 Replace wheel arbor shaft.
6 Replace arbor shaft bearing.
7 Replace belt pulley on clutch end.
8 Replace drive belt.
9 Replace front handlebar.
10 Replace cast arm from engine to wheel
11 Replace crankcase, crankcase gasket or re-seal crankcase. Includes air leak test.
12 Replace crankshaft main bearing(s). Includes air leak test.
13 Replace crankshaft seal(s). Includes air leak test.
14 Perform engine air leak test.
15 Replace cylinder and/or piston. Includes air leak test and repair of components causing failure.
16 Replace ignition module or flywheel. Includes stop circuit test.
17 Replace fuel tank line, vent line, or fuel pick-up body.
18 Replace intake or transfer port manifold or intake flange
19 Repair or replace carburetor. Includes fuel system testing.
20 Repair or replace rewind starter
21 Repair or replace clutch, clutch shoes or clutch springs.
22 Replace rear handle frame or handle housing
23 Replace muffler
24 Replace air filter or filter housing
25 Repair or replace stop switch. Includes circuit testing.
26 Replace fuel tank housing
27 Replace control panel. Includes electrical and run test.
28 Replace generator. Includes electrical and run test.
29 Replace solenoid valve. Includes electrical and run test.
30 Replace short circuit wire, air baffle. Includes electrical and run test.
40 Miscellaneous repairs and other repairs not listed.
45 Handling allowance only-no labor.
50 No Labor
© ANDREAS STIHL AG & Co. KG, 2010
TI_19_2010_30_01_01.fm
The repair times are specified in minutes.
Type of Repair

Technical Documentation

D1/MTK-fr
Page 11
TS410-A
TS420-A
20
25
15
15
25
25
15
15
25
160
170
70
30
90
25
40
35
45
15
20
30
25
15
35
60
25
30
20
25
15
10
0