Servicing Accessories; Spare Parts - Stihl Cutquik TS 410-A Technical Information

Page 4
3.

Servicing accessories

3.1 New special tools
3.1.1 Power adapter 4238 400 8500
The power adapter 4238 400 8500 permits fast
troubleshooting (see b 5.1, b 5.2).
3.1.2 Spacer 4238 894 1100
The flywheel must be removed with the previous
puller 1135 890 4500 (to be changed to
5910 890 4504) and the new spacer 4238 894 1100
(see b 5.3), in order to avoid damaging the
generator beneath it.
Technical Information 19.2010
3.2 Existing special tools
The existing special tools are listed in the Service
Manual for STIHL Cutquik
4.

Spare parts

The spare parts lists will be available for market
launch and are already contained on the DVD
STIHL Service Communication System (01/2010).
4.1 Clutch
In the new cut-off machines STIHL Cutquik
TS 410-A, TS 420-A, the new clutch 4238 160 2002
is used. In the new version, the previous tension
spring 0000 997 0912 with 6 coils is replaced by the
new version 0000 997 5510 with 7 coils.
In the new cut-off machines STIHL Cutquik
TS 410-A, TS 420-A, only the new clutch
4238 160 2002 should be used as a replacement
part.
5. Servicing
The safety instructions in the instruction manual
must be observed if the machine has to be started
up during servicing.
5.1 Troubleshooting Plan for the Electronic
Water Control
Possible customer complaint
– No water flow or water flow too low
– Water flow cannot be adjusted via the control
panel buttons
– System leaks
®
TS 410, 420.
®
®
TI_19_2010_30_01_01.fm