Install Appliance; Connect Electrical Supply - Gaggenau VK 414 610 Installation Instructions Manual

Install Appliance

9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1 Firmly insert the connecting lead from the
appliance on the control console. The plug must
engage. Plug the control cable on the appliance
in the socket. The plug must engage.
10
2 Evenly insert the unit in the cut-out. Press the unit
firmly into the cut-out from above.
Note: The unit must sit firmly in the cut-out and
must not move (e.g. during cleaning). If
necessary, secure strips at the sides in the cut-
out if the cut-out width is at the top tolerance
limit.
3 Connect the appliance to the mains and check
that it is working. If both illuminated rings behind
the control knobs flash alternately, the connecting
cable between the control console and the
appliance is not plugged in. Check that the
connecting cable is fitted correctly.
4
Flush installation only: it is imperative to test
functioning before jointing!
gap with a suitable, temperature-resistant silicone
adhesive (such as OTTOSEAL
the seal joint with smoothing agent recommended
by the manufacturer. Observe the notes on
processing the silicone adhesive. Do not operate
the appliance until the silicone adhesive has dried
completely (at least 24 hours, depending on room
temperature).
NOTICE:
Unsuitable silicone adhesive used on
natural stone worktops will cause permanent
discoloration.

Connect Electrical Supply

Refer to data plate for more information. See "Service"
for data plate location.
The branch-circuit breakers ampacity, the wire sizes
and the connections must be conform to the
requirements of the National Electrical Code or
Canadian Electrical Code and all local codes and
ordinances.
Joint the surrounding
® S 70). Smoothen