Table of Contents
Advertisement
Figure 5–10 Removing the System Board
Installing the
System Board
To install the system board, reverse the steps in the removal
procedure.
2
3
Follow antistatic precautions anytime a module
is replaced in the system. Refer to Antistatic
Precautions for details.
Carefully align the Halt switch and LEDs with
the openings in the rear of the chassis to prevent
damaging the switch.
Make sure the two mounting screws directly
behind the I/O board-to-system board connector
are installed with nylon washers to prevent a short
circuit.
1
MK428-16
Caution
Removal and Installation Procedures 5–23
System Board
Advertisement
Table of Contents
