Ethernet Chip And Jumper Locations - DEC 3000 Model 400S Installation & Owner's Manual

I/O Board
Note
After installing the I/O board, set the
environmental variables as they were on the
board being replaced. For information on setting
the variables, refer to the chapter, Changing
Environment Variables, in the DEC 3000 Model
400/400S AXP Owner's Guide or DEC 3000 Model
600/600S/700 AXP Owner's Guide as applicable.
Figure 5–9 Ethernet Chip and Jumper Locations
1
2
3
4
MK428-45
Removal and Installation Procedures 5–21