Turbochannel Options; Removing Turbochannel Options - DEC 3000 Model 400S Installation & Owner's Manual

TURBOchannel Options

TURBOchannel Options
Removing To remove a TURBOchannel option, refer to Figure 5–6, and
TURBOchannel proceed as follows:
Options
1. Prepare the system according to Preparing for Service earlier
2. Disconnect any external cables from the TURBOchannel
3. Remove the top cover according to Removing the Top Cover
4. If the TURBOchannel option is being replaced, note any
5. Remove the screws
5–14 Removal and Installation Procedures
Only standard height (1.36-inch) TURBOchannel
options can be used in the rackmount server.
If a dual width TURBOchannel option is installed,
it must be placed in slots 0 and 1. If necessary,
move the single width TURBOchannel option to
slot 2.
Follow antistatic precautions anytime a module
is replaced in the system. Refer to Antistatic
Precautions for details.
in this chapter.
option at the rear of the system.
earlier in this chapter.
switch settings or jumpers on the old TURBOchannel option
and set the switches or jumpers to the same value on the
new option. For other setup information, refer to the DEC
3000 Model 400/400S AXP Options Guide or the DEC 3000
Model 600/600S/700 AXP Options Guide as applicable.
located on the rear of the chassis that
secure the TURBOchannel option
Note
Caution
.