Free Arm; Leveling The Machine Base Plate; Thread Cutter; Spool Pins - Pfaff Passport 2.0 Owner's Manual

Free arm

To use the free arm, slide off the accessory tray.
When attached, a hook keeps the accessory tray
securely attached to the machine. Remove the tray
by sliding it to the left.

Leveling the machine base plate

To make sure your machine stands steadily on
your sewing surface you can adjust the base plate
height. Turn the base plate adjusting screw (A)
by hand. Turn clockwise to lower and counter-
clockwise to raise the base plate.

Thread cutter

To use the thread cutter, pull the thread from back
to front as shown (B).

Spool pins

Your machine has two spool pins, a main spool
pin and an auxiliary spool pin. The spool pins
are designed for many types of thread. The main
spool pin is adjustable and can be used both in a
horizontal position (the thread reels off the spool)
and a vertical position (the thread spool rotates).
The horizontal position can be used for most
sewing and embroidery threads, and the vertical
position can be used for many specialty threads.
Horizontal position
Place a spool cap and the thread spool on the spool
pin. Make sure that the thread reels over the top
and slide on the second spool cap.
Use a spool cap slightly larger than the thread
spool.
For narrow thread spools, use a smaller spool cap
in front of the spool. For large thread spools, use a
larger spool cap in front of the spool.
between the spool cap and the thread spool.
10
Large spool cap
Small spool cap
A
B