Buttons - Pfaff Passport 2.0 Owner's Manual

Buttons passport™ 3.0
8
7
6
4
2
1
If you press the reverse button while sewing, the
machine sews in reverse for as long as you keep the
button pressed.
Reverse is also used when sewing the darning
stitch.
Press this button to start or stop the machine
without using the foot control. Press the button
once to start and press it again to stop.
The speed control lever sets the maximum sewing
speed. To increase sewing speed, slide the lever up,
to decrease sewing speed, slide the lever down.
Press this button when you are not sewing and the
machine cuts the top and bobbin threads. Press this
the stitch, perform a tie-off and cut the top and
bobbin threads.
For immediate tie-off press the button while
sewing. The machine sews tie-off stitches
immediately and stops automatically.
To set the machine to perform a tie-off at the end
of a stitch, press the button before starting to sew.
The LED light next to the button becomes lit. After
sewing the desired length of stitching, press the
reverse button while actively sewing. The machine
will complete the current stitch, tie-off and stop
automatically.
18
5 9
3
Note: The tie-off function is not available for stitches
16-21.
Press this button to move the needle up or down.
The setting of the needle stop position is changed
at the same time.
You can also tap the foot control to raise or lower
the needle.
Increase or decrease the stitch length using the "+"
and "-" buttons.
Increase or decrease the stitch width using the "+"
and "-" buttons.
For straight stitches, use the "+" and "-" buttons to
change the stitch position.
Note: There are 29 needle positions available. 3.5 on the
display is the center position.
Press this button to show the presser foot
recommendation on the LED display. If a dot is
visible in the lower right corner of the screen, the
IDT™ system should be engaged.
Press a combination of the 0 to 9 buttons to select
the stitch represented by that number.
10