Starting Off; Acceleration And Deceleration - Yamaha Tricity MW125A Owner's Manual

The ABS warning light should
come on when the main switch is
turned to "ON" and then go off af-
ter traveling at a speed of 10 km/h
(6 mi/h) or higher.
NOTICE
If the ABS warning light does not
come on and then go off as ex-
plained above, see page 3-2 for the
warning light circuit check.
2. Close the throttle completely.
3. Start the engine by pushing the
start switch while applying the
front or rear brake.
If the engine fails to start, release
the start switch, wait a few sec-
onds, and then try again. Each
starting attempt should be as
short as possible to preserve the
battery. Do not crank the engine
more than 10 seconds on any one
attempt.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
cold!
OPERATION AND IMPORTANT RIDING POINTS

Starting off

1. While pulling the rear brake lever
with your left hand and holding the
grab bar with your right hand,
push the vehicle off the center-
ECA17682
stand.
1
1. Grab bar
2. Sit astride the seat, and then ad-
just the rear view mirrors.
3. Switch the turn signals on.
4. Check for oncoming traffic, and
then slowly turn the throttle grip
(on the right) in order to take off.
ECA11043 5. Switch the turn signals off.
http://www.motorcycle.in.th
EAU60640

Acceleration and deceleration

The speed can be adjusted by opening
and closing the throttle. To increase
the speed, turn the throttle grip in di-
rection (a). To reduce the speed, turn
the throttle grip in direction (b).
5-2
EAU16782
(b)
(a)
5