Yamaha Tricity MW125A Owner's Manual page 76

VEHICLE CARE AND STORAGE
off any detergent residue using
plenty of water, as it is harmful
to plastic parts.
 Do not use any harsh chemical
products on plastic parts. Be
sure to avoid using cloths or
sponges which have been in
contact with strong or abrasive
cleaning products, solvent or
thinner, fuel (gasoline), rust re-
movers or inhibitors, brake fluid,
antifreeze or electrolyte.
 Do not use high-pressure wash-
ers or steam-jet cleaners since
they cause water seepage and
7
deterioration in the following ar-
eas: seals (of wheel and swing-
arm bearings, fork and brakes),
electric components (couplers,
connectors,
switches and lights), breather
hoses and vents.
 For vehicles equipped with a
windshield: Do not use strong
cleaners or hard sponges as
they will cause
Some
scratching.
compounds for plastic may
leave scratches on the wind-
shield. Test the product on a
small hidden part of the wind-
shield to make sure that it does
not leave any marks. If the wind-
shield is scratched, use a quality
plastic polishing compound af-
ter washing.
NOTICE
Use care when cleaning the radiator.
High-pressure washers may dam-
age the radiator fins. Do not spray
the radiator fins at an angle, and al-
ways keep the nozzle at least 50 cm
(20 in) away from the spins when
spraying.
After normal use
Remove dirt with warm water, a mild
instruments,
detergent, and a soft, clean sponge,
and then rinse thoroughly with clean
water. Use a toothbrush or bottlebrush
for hard-to-reach areas. Stubborn dirt
and insects will come off more easily if
the area is covered with a wet cloth for
dulling or
a few minutes before cleaning.
cleaning
http://www.motorcycle.in.th
After riding in the rain, near the sea, or
on salt-sprayed roads
Since sea salt or salt sprayed on roads
during winter are extremely corrosive
in combination with water, carry out
the following steps after each ride in
the rain, near the sea, or on salt-
sprayed roads.
ECAU0061
TIP
Salt sprayed on roads in the winter
may remain well into spring.
1. Clean the vehicle with cold water
2. Apply a corrosion protection spray
Cleaning the windshield
Avoid using any alkaline or strong acid
cleaner, gasoline, brake fluid, or any
other solvent. Clean the windshield
with a cloth or sponge dampened with
a mild detergent, and then wash it off
7-2
and a mild detergent after the en-
gine has cooled down.NOTICE:
Do not use warm water since it
increases the corrosive action
of the salt.
[ECA10792]
on all metal, including chrome-
and nickel-plated, surfaces to pre-
vent corrosion.