MTU 12 V 2000 G25 Operating Instructions Manual page 59

Fault
code no. Full designation
358 AL Open Load Cylinder
B8
359 AL Open Load Cylinder
B9
360 AL Open Load Cylinder
B10
361 AL Power Stage Low
362 AL Power Stage high
363 AL Stop Power Stage
Meaning
Disruption fault in injector
wiring cylinder B8. Result:
Misfiring (alarm configuration
parameter, see PR
2.8008.100 for explanation).
Disruption fault in injector
wiring cylinder B9. Result:
Misfiring (alarm configuration
parameter, see PR
2.8008.100 for explanation).
Disruption fault in injector
wiring cylinder B10. Result:
Misfiring (alarm configuration
parameter, see PR
2.8008.100 for explanation).
Internal electronic fault (elec-
tronics may be defective). If
parameter 1.1020.021 (Pow-
er Stage Failure: Stop En-
gine) is set, engine is stop-
ped here additionally (alarm
configuration parameter, see
PR 2.8008.100 for explana-
tion).
Internal electronic fault (elec-
tronics may be defective). If
parameter 1.1020.021 (Pow-
er Stage Failure: Stop En-
gine) is set, engine is stop-
ped here additionally (alarm
configuration parameter, see
PR 2.8008.100 for explana-
tion).
Internal electronic fault (elec-
tronics may be defective). If
parameter 1.1020.021 (Pow-
er Stage Failure: Stop En-
gine) is set, engine is stop-
ped here additionally (alarm
configuration parameter, see
PR 2.8008.100 for explana-
tion).
MS15018/02E 2013-09 | Troubleshooting | 59
Setting parame-
Action ter no.
Check injector wir- 1.8004.557
ing, exclude disrup-
tion in solenoid
valve (e.g. by injec-
tor replacement).
Fault rectification:
After each working
cycle.
Check injector wir- 1.8004.558
ing, exclude disrup-
tion in solenoid
valve (e.g. by injec-
tor replacement).
Fault rectification:
After each working
cycle.
Check injector wir- 1.8004.559
ing, exclude disrup-
tion in solenoid
valve (e.g. by injec-
tor replacement).
Fault rectification:
After each working
cycle.
Start engine gover- 1.8004.496
nor self-test. Re-
place engine gover-
nor in case of fault;
if self-test diagnoses
"Electronics OK"
check for additional
fault messages (e.g.
wiring fault).
Start engine gover- 1.8004.497
nor self-test. Re-
place engine gover-
nor in case of fault;
if self-test diagnoses
"Electronics OK"
check for additional
fault messages (e.g.
wiring fault).
Start engine gover- 1.8004.560
nor self-test. Re-
place engine gover-
nor in case of fault;
if self-test diagnoses
"Electronics OK"
check for additional
fault messages (e.g.
wiring fault).