MTU 12 V 2000 G25 Operating Instructions Manual page 58

Fault
code no.
352
353
354
355
356
357
58 | Troubleshooting | MS15018/02E 2013-09
Full designation Meaning
AL Open Load Cylinder Disruption fault in injector
B2 wiring cylinder B2. Result:
Misfiring (alarm configuration
parameter, see PR
2.8008.100 for explanation).
AL Open Load Cylinder Disruption fault in injector
B3 wiring cylinder B3. Result:
Misfiring (alarm configuration
parameter, see PR
2.8008.100 for explanation).
AL Open Load Cylinder Disruption fault in injector
B4 wiring cylinder B4. Result:
Misfiring (alarm configuration
parameter, see PR
2.8008.100 for explanation).
AL Open Load Cylinder Disruption fault in injector
B5 wiring cylinder B5. Result:
Misfiring (alarm configuration
parameter, see PR
2.8008.100 for explanation).
AL Open Load Cylinder Disruption fault in injector
B6 wiring cylinder B6. Result:
Misfiring (alarm configuration
parameter, see PR
2.8008.100 for explanation).
AL Open Load Cylinder Disruption fault in injector
B7 wiring cylinder B7. Result:
Misfiring (alarm configuration
parameter, see PR
2.8008.100 for explanation).
Setting parame-
Action ter no.
Check injector wir- 1.8004.551
ing, exclude disrup-
tion in solenoid
valve (e.g. by injec-
tor replacement).
Fault rectification:
After each working
cycle.
Check injector wir- 1.8004.552
ing, exclude disrup-
tion in solenoid
valve (e.g. by injec-
tor replacement).
Fault rectification:
After each working
cycle.
Check injector wir- 1.8004.553
ing, exclude disrup-
tion in solenoid
valve (e.g. by injec-
tor replacement).
Fault rectification:
After each working
cycle.
Check injector wir- 1.8004.554
ing, exclude disrup-
tion in solenoid
valve (e.g. by injec-
tor replacement).
Fault rectification:
After each working
cycle.
Check injector wir- 1.8004.555
ing, exclude disrup-
tion in solenoid
valve (e.g. by injec-
tor replacement).
Fault rectification:
After each working
cycle.
Check injector wir- 1.8004.556
ing, exclude disrup-
tion in solenoid
valve (e.g. by injec-
tor replacement).
Fault rectification:
After each working
cycle.