Honda 08E91-T2A-100 Installation Instructions Manual page 26

Installing the Control Unit
88. Using isopropyl alcohol on a shop towel, clean the
area where the urethane tape will attach.
VEHICLE UNIT
89. Attach one urethane tape to the vehicle unit as
shown.
90. Plug the antenna cable connector and the engine
starter harness 28-pin connector into the control
unit.
CONTROL
UNIT
ENGINE STARTER
HARNESS 28-PIN
CONNECTOR
26 of 35
URETHANE
TAPE
Clean with
Q0N2305AG
isopropyl alcohol.
ANTENNA
CABLE
CONNECTOR
QC50917AB
AII 00273 (1410)
91. Install the control unit bracket to the control unit.
CONTROL
UNIT
92. Secure the clip from the engine starter harness fuse
block, and the clip from the engine starter harness
into the holes in the control unit bracket.
CONTROL UNIT
BRACKET HOLE
HOLE
© 2014 American Honda Motor Co., Inc. – All Rights Reserved.
CONTROL UNIT
BRACKET
QC50918AB
CLIP
FUSE
BLOCK
ENGINE
STARTER
HARNESS
CLIP
Q0N2308BG