Honda 08E91-T2A-100 Installation Instructions Manual page 13

38. Plug the three relays into the relay block on the
engine starter harness.
RELAY
20A FUSE
LABEL
FUSE
BLOCK
RELAY
BLOCK
ENGINE STARTER
HARNESS
39. Using isopropyl alcohol on a shop towel, thoroughly
clean the relay block and fuse block where the
3A fuse labels and 20A fuse labels will attach.
40. Attach the two 3A fuse labels and two 20A fuse
labels to the relay block and fuse block on the engine
starter harness.
© 2014 American Honda Motor Co., Inc. – All Rights Reserved.
Clean with
isopropyl alcohol.
20A FUSE
LABEL
2 RELAYS
3A FUSE
LABELS
If the vehicle is Touring grade go to step 48, otherwise
continue with step 41:
Except Touring Grade
41. Route the two 28-pin connectors of the engine
starter harness upward as shown.
ENGINE STARTER
HARNESS
28-PIN CONNECTOR
QD22116AY
42. Unplug the vehicle 28-pin connector.
ENGINE STARTER
HARNESS
28-PIN CONNECTOR
43. Route the engine starter harness 28-pin connectors
as shown, and plug the engine starter harness
28-pin connector into the vehicle 28-pin connector.
AII 00273 (1410)
STEERING
HANGER BEAM
ENGINE STARTER
HARNESS
VEHICLE
28-PIN
CONNECTOR
QD90206AG
QD90207AG
13 of 35