Operating Radio Throttle/Brake And Reverse - THUNDER TIGER Hammer S18 Instruction Manual

6
OPERATING RADIO THROTTLE/ BRAKE AND
REVERSE FUNCTION
遙控器設定－油門、煞車、後退
a
d
a. Check the radio throttle/brake functions. With the radio transmitter and receiver on, pull the trigger/push the stick forward. The
carburetor should be fully opened and the brake disengaged. To reverse this function, flip the throttle/brake servo reverse switch.
b. Return the trigger/stick to neutral. The carburetor should be closed to a point where the idle has been set (see step for ADJUSTING
THROTTLE/BRAKE LINKAGE), and the brake still disengaged. If not, use the throttle/brake trim lever to correct it.
c. Push the trigger/pull the stick backward. The carburetor opening should still be the same at neutral, throttle spring compressed
slightly, and the brake engaged.
d. Press the Forward/Reverse Button. This will shift the truck into Reverse. Press the Forward/Reverse Button again to shift the
truck into Forward.
a. 請先將發射機與接收機電源開關打開，以檢查油門、煞車作動是否正常作動。將油門板手向內拉到底時，化油器應完全開啟，煞車
脫離（可輕輕轉動後輪，確認煞車是否完全脫離）。
b. 將油門板機推回中立點時，化油器應關閉至定點，煞車仍為脫離狀態；若狀態有所偏差，請調整油門微調鈕。
c. 油門板機向外推時，化油器應關閉至定點，且煞車須為鎖死狀態。
d. 壓下倒退鈕（位置如圖示）。車輛行進方向將變為倒退；再壓一下倒退鈕，車輛行進方向將變回前進。
b
d
c
c