Battery Installation & Charging - AT&T CL84109 User Manual

Getting started
Battery installation & charging
Install the battery as shown below.
screen indicates the battery status (see table below). If necessary, place the
handset in the telephone base or charger to charge the battery. For best
performance, keep the handset in the charger when not in use. The battery is
fully charged after 16 hours of continuous charging.
for battery operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 10 minutes to give the handset enough charge to use the telephone
for a short time. The screen shows LOW BATTERY and the backlight is off until
you have charged the battery without interruption for at least one hour. The
following table summarizes the battery charge indicators and actions to take.
Battery indicators
The screen is blank.
The screen shows PLACE IN
CHARGER and
The screen shows LOW
BATTERY and flashes.
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every
minute.
Plug the battery connector
securely into the socket
inside the handset battery
compartment, matching the
color-coded label. Insert
the supplied battery with
the label THIS SIDE UP
facing up as indicated.
Battery status
Battery has no charge and
the handset cannot be used.
Battery has very little charge
flashes. and the handset cannot be
used.
Battery has enough charge
to be used for a short time.
Battery is charged.
Step 1
Once you have installed the battery, the
8
See the table on page 85
Action
Charge without interruption until
the screen shows LOW BATTERY
(at least 10 minutes).
Charge without interruption until
the screen shows LOW BATTERY
(at least four minutes).
Charge without interruption until
the screen shows HANDSET X (at
least one hour).
To keep the battery charged,
place it in the charger when not
in use.
Step 2
Align the cover flat against
the battery compartment,
then slide it upwards until it
clicks into place.